rgcaraudio
|
Open Question
amp, 2 ohm dvc power acoustics?
ok i got 3 ten inch 2ohm dual voice coil power acoustik fubrs. had 4 1 blew. rockford fosgate punch 800.2, that has a gain problem (broken gain knob and the frequency selector just turns instead of stoping at the highest and lowest point. well this is the same amp i blew 1 of my L5s with. is there a way to salvage this amp? so my subs are not clipping from the over extended gain on 1 of the channels? also on the fubrs i wired them up to 4 ohms each ( running a wire from the positive of 1 voice coil to the negative of the other voice coil, then running a set of wire too the remainging 2 voice coils, per speaker) so by doing that i would be creating 3 seperate 4ohm loads, this is series wiring i think. what would be the best way 2 wire my subs safely, i know it depends on the amp, if i cant get my hands on another 10" power acoustic fubr 2ohm dvc sub 600rms what would be closest to one of them. would a alpine r type mesh in with the family well? help sugestions anything will be appreciated! thx matt.
Posted 698 days ago
 Report Abuse
|
